Safety Information; Error Display; Warranty; Intended Use On Instrument - geo-FENNEL ELT 220 Mode D'emploi

SAFETY INFORMATION

ERROR DISPLAY

Display
E01 Vertical angle "0" position is out of range or set with incorrect procedure.
E04 Internal memory system error.
E05 Reserved for factory adjustment.
E06 Failure in angle measuring system.
E07 Rotation speed of telescope was too fast (over 4 r/s).
E08 Angle measuring system error. The instrument should be powered off/on to eliminate
this error.
Attention:
Fully check every part of the instrument and see whether the operation coincides with the
procedures after the error appears. If the error code is still shown after many checks please
send the instrument for repair.

WARRANTY

This product is warranted by the manufacturer to the original purchaser to be free from
defects in material and workmanship under normal use for a period of two (2) years from
the date of purchase. During the warranty period, and upon proof of purchase, the product
will be repaired or replaced (with the same or similar model at the manufacturers discreti-
on), without charge for either parts or labour. In case of a defect please contact the dealer
where you originally purchased this product. The warranty will not apply to this product if it
has been misused, abused or altered. Without limiting the foregoing, leakage of the battery,
bending or dropping the unit are presumed to be defects resulting from misuse or abuse.
INTENDED USE OF INSTRUMENT
Triangle, polygon and engineer measurements in the field of civil engineering as well as
cadastral survey.
Error Content
ECOLINE
EN
5
27