Printer / Data Logger Setup - SciCan HYDRIM M2 G4 Mode D'emploi

6. Storing and Retrieving Cycle Information

6.3 Printer / Data Logger Setup

The HYDRIM M2 G4 has an RS-232 port at the back, and can be used with an external
printer or the SciCan Data Logger. The printers in the chart below have been tested with
the HYDRIM. To add or change a printer or SciCan Data Logger, follow these steps:
Turn off the HYDRIM and the printer or Data Logger before connecting these devices to
the unit.
1.
With the printer or Data Logger connected, turn on the HYDRIM and press the i to
move to the Menu screen.
2.
In the Setup Menu, select
Printer Selection.
3.
Select Serial Printer if
connecting a printer, or USB
Flash/MSD if connecting the
SciCan Data Logger. Press
the back arrow to return to the
Setup Menu.
4.
In the Setup Menu, select Baud
rate.
5.
Select the rate required (refer to
chart below for recommended
Baud rates). Use the back
arrow to return to the Start
screen.
6.
Ensure that the date and time
have been set (see Setup Menu
– Date / Time)
7.
Now the HYDRIM will write its
cycle information to the device
chosen.
Printer Model
Epson
TM-U220D (C31C515603)
Citizen
IDP-3110-40 RF 230B
Star Micro
SP212FD42-230
Star Micro
SP216FD42-230
Star Micro
SP512MD42-R
SciCan Data Logger
For Mass Storage Device
31
Serial Port
Baud Rate
9600
9600
9600
9600
9600
Serial Port
Baud Rate
9600