Disclaimers - SciCan HYDRIM M2 G4 Mode D'emploi

3. Disclaimers

Do not permit any person other than authorized personnel to supply parts for service
or maintainance for your HYDRIM M2 G4. SciCan shall not be liable for incidental,
special or consequential damages caused by any maintenance or services performed
on the HYDRIM M2 G4 by unauthorized personnel, or for the use of equipment or parts
manufactured by a third party, including lost profits, any commercial loss, economic
loss, or loss arising from personal injury.
Never remove the cover of the unit and never insert objects through holes or openings
in the cabinetry. Doing so may damage the unit and / or pose a hazard to the operator.
If the unit is used in a manner other than that specified, the protection provided by the
equipment may be impaired.
Allow only trained and authorized personnel to operate the unit.
Cleaning solutions may irritate. Avoid contact with eyes and mouth.
Never sit, stand or lean on the open door. The unit may tip forward causing injury.
OFF
Always turn the unit before adding softener salt, adding solutions or performing
routine maintenance to the unit.
The owner shall not allow any personnel other than the trained and authorised
personnel to operate the unit.
SciCan recommends leaving the unit turned ON at all times, in particular over times
when no staff is in the office or when no water shut-off mechanism is installed. Leaving
the unit turned ON will activate the drain pump if water is leaking into the chamber as a
result of any faulty circumstance.
The HYDRIM M2 G4 uses HIP™ Cleaning Solution exclusively. The unit might not
perform as described if other detergents / cleaning products are used. Furthermore,
the HYDRIM M2 G4 is only validated with HIP™ Cleaning Solution. Other detergents
/ cleaning products may damage the unit, the instruments, cause excessive foaming,
and void the warranty. Do not use solvents in this unit. Do not allow small children or
unauthorised personnel access to this unit or its controls.
5