Invacare Aquatec KOGIA Manuel D'utilisation page 20

Aquatec® KOGIA
4. Hold the backrest at the head end with one hand and
slowly fold the backrest forwards to the end position.
Risk of Damage
– Do not fold the backrest down if there is
water in the bathtub.
– Before folding the backrest down, ensure
that the backrest is completely in the
lowered position.
– When folding the backrest down, ensure
that the spiral cable of the hand control
does not become trapped.
5.
Pull the backrest up off the seat and out of the bathtub.
6. Fold the side flaps of the seat inwards.
20
Fig. 6-2
7.
Release the rear suction cups A by pulling up on the
protruding tabs B.
Release both rear suction cups simultaneously.
8. Lift the rear of the seat slightly. This releases the front
suction cups.
If the height adapters have been installed
(optional), you also have to pull the tabs of the
front suction cups to release them.
9. Take the base frame with seat plate out of the bathtub.
Make sure that all suction cups are detached
before taking the seat out of the bathtub.
10. Carefully store all components of the bath lift.
Fig. 6-3
1584939-B