Installing The Main Landing Gear - Reely Sky Fournier Rf-4D Notice D'emploi

p) Installing the Main Landing Gear
Remove the iron-ion foil above the main landing gear slot (1) at the bottom of the
wings with a soldering gun.
Draw the bore holes (2) and pre-drill the holes with a 2 mm drill. Expand the holes
in the attachment tabs (3) to 3 mm and screw the tabs on with the included
3 x 10 mm screws.
Important!
The shorter piece of the landing gear wire (4) must be pushed into
the area and the wheel (4) is pushed onto the longer piece.
Secure the wheel with the adjustment ring (5).
Figure 25
43