Mounting The Wings - Reely SKY Fournier RF-4D Notice D'emploi

d) Mounting the Wings
Melt the iron-on foil above the bores (1) for the wing holder away with a soldering
gun.
Push the wing holder (2) into the intended bores and align the holder centrally.
Glue to the fuselage with thin superglue.
Apply the wing to the fuselage from the bottom and attach it with the included
rubber rings (1).
Important!
The wing always has to be aligned precisely. The connection seam
of both wing halves (2) must match the fuselage centre line (3)
precisely. Then the two distances "A" according to the sketch are
always the same length.
34
Figure 7
Figure 8