Introduction; Intended Use; Product Description - Reely Sky Fournier Rf-4D Notice D'emploi



1. Introduction

Dear Customer,
Thank you for purchasing this product.
This product complies with the statutory national and European requirements.
To maintain this status and to ensure safe operation, you as the user must observe these operating instructions!
These operating instructions are part of this product. They contain important notes on commissioning and handling. Also consider this
if you pass on the product to any third party.
Therefore, retain these operating instructions for reference!
All company names and product names are trademarks of their respective owners. All rights reserved.
If there are any technical questions, contact:
Tel. no.: +49 9604 / 40 88 80

Fax. no.: +49 9604 / 40 88 48
E-mail: tkb@conrad.de
Mon. to Thur. 8.00am to 4.30pm
Fri. 8.00am to 2.00pm


2. Intended Use

This product is an electrically powered model airplane which is radio controlled by a remote control system to be purchased separately. The model is intended
for outdoor use and should only be flown on days with weak or no wind. The plane is pre-assembled and can be completed very quickly.
The product must not become damp or wet.
The product is not suitable for children under 14 years of age.
Observe all safety information in these operating instructions. They contain important information on handling of the product.
You alone are responsible for the safe operation of the model!


3. Product Description

The flight model "Fournier RF-4D" is an ARF model (Almost Ready to Fly) already mainly pre-assembled that is suitable for experienced model pilots because
of its design.
The fuselage, wings and tail units are made of laser-cut wooden parts and already applied with multi-coloured iron-on film. The top of the fuselage is made from
impact-resistant ABS plastic.
The model is prepared for installation in drive and remote control components and all required small parts are included with the plane.
For simple ground starts, the model is equipped with a two-leg landing gear and a controllable tail wheel.
The model can be controlled via 3 axes and equipped with the required remote control and drive components without any great effort, and completed very
quickly. The controllable functions are: Aileron (control around the longitudinal axis), elevator (control around the transverse axis) and rubber (control around the
vertical axis) and electric motor speed control.
26