Toro Emotion 43 Série Mode D'emploi page 45

TROUBLESHOOTING
Problem Possible cause
Motor does not start.
1. Fuel tank is empty.
2. Air filter element is dirty.
3. Spark plug is loose.
4. Ignition cable is loose or has
come off the spark plug.
5. Electrode distance is not
correct.
6. Spark plug is defective.
7. The carburetor is flooded.
8. Ignition system defective (no
ignition spark).
9. Cutter is loose.
10. Motor stop is active.
1. Battery low or empty
Only for mowers with
electric start
1. Dirt or water in fuel tank.
Motor starts with
difficulty, is not running
2. Vent hole in fuel tank cover
smoothly or loses
is blocked.
power.
3. Air filter is soiled.
4. Cutter screw is loose.
Remedial measures
1. Refill fuel tank. Motor starts with
difficulty, is not running
2. Clean air filter element.
smoothly or loses
power.
3. Tighten spark plug. Torque: 20
Nm.
4. Attach ignition cable to the spark
plug.
5. Adjust electrode distance to 0.75
mm.
Motor has spark
failures at high speed.
6. Mount new spark plug.
7. Remove air filter element. Pull
starter rope several times until
Motor overheated.
the carburetor is empty and the
motor starts. As soon as the
motor starts, turn it off and
mount the air filter element.
8. Consult TORO customer
service.
9. Consult TORO customer Motor has irregular
service.
vibrations.
10. Pull back safety lever.
1. Charge battery
Only mower with
wheel drive
1. Drain fuel and clean tank, refill
Wheel drive turned not
tank with fresh, clean fuel.
off or mower moves
forward in jolts
2. Clean or replace tank cover.
3. Clean air filter element.
4. Consult TORO customer
Wheel drive turned in
service.
but mower does not
move.
TROUBLESHOOTING
Problem Possible cause
5. Spark plug is defective.
6. Vent openings in motor hodd
blocked.
7. Cooling fins and vent holes
below the fan housing are
blocked.
1. Electrode distance of spark
plug too small.
1. Cooling air flow is obstruc-
ted.
2. Electrode distance of spark
plug incorrect.
3. Wrong spark plug.
1. Cutter screw is loose.
2. Cutter has not been balan-
ced.
3. There is too much grass in
the mowing channel.
1. Bowden cable for wheel
drive is misadjusted.
2. Clutch release fork lever has
wrong adjustment or is
defective.
3. Clutch is defective.
1. V belt defective.
2. Free-wheel defective.
Remedial measures
5. Adjust electrode distance to 0.75
mm or mount new spark plug.
6. Clean vent openings.
7. Clean cooling fins and vent holes.
1. Adjust electrode distance to
0.75 mm.
1. Clean vent openings in the hood,
in the fan housing and the cooling
fins on the motor.
2. Adjust electrode distance to
0.75 mm.
3. Mount correct spark plug with an
electrode distance of 0.75 mm.
1. Consult TORO customer service.
2. Consult TORO customer service.
3. Clean mower..
1. Adjust the Bowden cable for the
wheel drive
(see page 40)
2. Consult TORO customer service.
3. Consult TORO customer service.
1. Consult TORO customer service.
2. Consult TORO customer service.
45