Ego Power+ CS1200 Guide D'utilisation page 45

PROBLEM
Chain saw does
not cut properly.
Chain becomes
loose or drops
off the guide bar
during normal
use.
CORDLESS 12" COMPACT CHAIN SAW — CS1200/CS1200-FC
CAUSE
◾
Insufficient chain tension.
◾
Dull chain.
◾
Chain installed backwards.
◾
Worn chain.
◾
Dry or excessively stretched
chain.
◾
Chain not in bar groove.
◾
The chain will become
loose as the temperature of
the chain increases during
normal saw operation.
◾
Chain does not engage drive
sprocket.
SOLUTION
◾
Tension the chain following the
section "ADJUSTING THE CHAIN
TENSION" until the chain is
correctly tensioned.
◾
Sharpen the chain cutters, following
the section: "HOW TO SHARPEN
THE CUTTERS".
◾
Remove the battery pack and
reinstall the saw chain, following the
section "REPLACING THE BAR AND
CHAIN"
◾
Remove the battery pack and
replace the chain following the
section "REPLACING THE BAR AND
CHAIN".
◾
Check the oil level. Refill the oil tank
if necessary.
◾
Remove the battery pack and
reinstall the saw chain, following the
section "REPLACING THE BAR AND
CHAIN".
◾
Tension the chain following the
section "ADJUSTING THE CHAIN
TENSION" until the chain is
correctly tensioned.
◾
Remove the battery pack and
reinstall the chain, following the
section "REPLACING THE BAR AND
CHAIN". Ensuring that the drive
links on the chain are fully seated
onto the sprocket.
45