Ego Power+ CS1200 Guide D'utilisation page 30

Always remove the chain saw from a wood cut while the saw is running. Release the
trigger switch as soon as the cut is completed, allowing the chain to stop.
WARNING:
release the trigger switch; remove the saw chain and guide bar from the wood,
then restart the chain saw.
WARNING:
the sawdust. Serious injury could result if the chain saw starts accidentally.
Press the saw chain against the wood, move the chain saw back and forth to
discharge the debris. Always remove the battery pack before cleaning. Wear
heavy protective gloves when handling the saw chain.
WARNING:
Always allow the chain saw reach full speed before applying the saw to the
wood.
LIMBING
Limbing is removing branches from a
fallen tree. When limbing, leave larger
limbs to support the log off the ground.
Remove the small limbs in one cut as
illustrated in Fig. 16. Branches under
tension should be cut from the bottom up
to avoid binding the chain saw.
WARNING:
danger of kickback during the limbing operation. Be extremely cautious and
avoid contacting the log or other limbs with the tip of the guide bar.
30
CORDLESS 12" COMPACT CHAIN SAW — CS1200/CS1200-FC
When the saw chain is stopped due to pinching during cutting,
Do not pull the saw chain with your hand when it is bound by
Never start the chain saw when it is in contact with the wood.
There is an extreme
16
Tree Limbing
Limb Cut