Ego Power+ CS1200 Guide D'utilisation page 35

3. Place the chain drive links into the
guide bar groove. Position the chain
so there is a loop at the back of the
guide bar (Fig. 24a).
4. Hold the chain in position on the
guide bar and place the loop around
the drive sprocket of the saw.
NOTICE:
When looping the saw chain
onto the guide bar, make sure that after
mounting the guide bar onto the saw,
the cutter orientation matches the cutter
icon and rotation direction arrow on the
housing of the saw (Fig. 24b). If they face
in opposite directions, reassemble the
saw chain onto the guide bar with the
cutters facing the same direction
(Fig. 24c).
NOTE: Tension the chain by following
instructions in the chapter "ADJUSTING
THE CHAIN TENSION" in the next section.
5. Place the guide bar on the mounting
surface by sliding the guide-bar slot
over the alignment flanges. Make
sure that the guide bar is correctly
positioned over the fastening bolt.
NOTICE:
During assembly and
maintenance, the metal plate underneath
the guide bar (Fig. 24d) may pop up. If
this happens, clean the gap between this
metal piece and the housing thoroughly
and push the metal plate back so it is
flush against the housing. Failure to
clean and properly place the metal plate
will cause the guide bar misalignment.
CORDLESS 12" COMPACT CHAIN SAW — CS1200/CS1200-FC
24a
Guide Bar
Groove
24b
Drive
Sprocket
Fastening Bolt
24c
24d
Chain Drive
Links
Rotation
Direction Arrow
Alignment
Flange
Metal
Plate
Housing
35