Publicité
Les langues disponibles
Les langues disponibles
NOTICE:
A chain tensioned while it is warm may be too tight upon cooling. Check the
cold tension before next use.
CHAIN MAINTENANCE
WARNING:
sharp and may contain burrs.
WARNING:
Failure to heed this warning could result in serious personal injury.
Only use low-kickback chains on this saw. This fast-cutting chain will provide kickback
reduction when properly maintained.
A properly sharpened saw chain cuts through wood effortlessly, even with very little
pressure. Never use a dull or damaged saw chain. A dull saw chain cutter leads to
increased physical strain, increased vibration load, unsatisfactory cutting results and
increased wear.
For smooth and fast cutting, the saw chain needs to be maintained properly. The
chain requires sharpening when the wood chips are small and powdery, the chain
must be forced through the wood during cutting, or the chain cuts to one side. During
maintenance of your saw chain, consider the following:
◾
Improper filing angle of the side plate can increase the risk of a severe kickback.
◾
Raker (depth gauge) clearance. Too low increases the potential for kickback. Not
low enough decreases cutting ability.
◾
If cutter teeth have hit hard objects, such as nails and stones, or have been
abraded by mud or sand on the wood, have the chain sharpened by a qualified
service technician.
NOTICE:
Inspect the drive sprocket for wear or damage when replacing the chain.
If signs of wear or damage are present in the areas indicated, have the drive sprocket
replaced by qualified service technician.
CORDLESS 12" COMPACT CHAIN SAW — CS1200/CS1200-FC
Always wear gloves when handling the saw chain. The chain is
Remove the battery pack before performing any maintenance.
37
Publicité
