Publicité
Les langues disponibles
Les langues disponibles
6. Attach the side cover to the housing
so that the holes/pins and fastening
bolt/thread hole are aligned with
each other properly (Fig. 25).
Lightly tighten the side-cover knob
by turning it clockwise. The bar
must be free to move for tension
adjustment.
NOTICE:
To extend the guide-bar life,
invert the bar occasionally.
WARNING:
ADJUSTING THE CHAIN TENSION
1. Make sure that the battery pack is
removed.
2. Lift up the tip of the guide bar and
keep it slightly lifted as you adjust
the tension. Ensure that the guide
bar has some movement; loosen
the side-cover knob slightly, if
necessary.
3. Turn the chain-tensioning knob clockwise to tighten or counterclockwise to
loosen, until all chain sections are just touching the bottom edge of the guide.
NOTE:
◾
A cold chain is correctly tensioned when there is no slack on the underside of the
guide bar and the chain is snug, but it can be turned by hand without binding. The
chain must be re-tensioned whenever the flats on the drive links do not sit in the
bar groove.
◾
During normal saw operation, the temperature of the chain will increase. The
drive links of a correctly tensioned warm chain will hang approximately 3/64" –
5/64" (1 – 2 mm) out of the bar groove (Fig. 26).
NOTICE:
New chains tend to stretch. Check chain tension frequently and adjust
tension as required.
36
CORDLESS 12" COMPACT CHAIN SAW — CS1200/CS1200-FC
The saw chain must be properly tensioned before using.
25
Housing
Side Cover
26
3/64" – 5/64" (1 – 2 mm)
Publicité
