Reely Dune Fighter Notice D'emploi page 53

Setting front axle alignment:
For the front axle, alignment can be set by turning the adjustment
screw (1) at the steering linkage.
Because the adjustment screw has a left and right hand thread at
either end, it does not need to be dismantled to be twisted.
Turn both adjustment screws evenly (left and right front
wheel). Otherwise, you need to correct the trim of the
transmitter or even adjust the steering servo control
(e.g. adjust servo rod or attach servo arm to the servo
differently).
Setting rear axle alignment:
For the rear axle, alignment can be set by turning the adjustment
screw (1).
Because the adjustment screw has a left and right hand thread at
either end, it does not need to be dismantled to be twisted.
Always twist both adjustment screws evenly (left and
right rear wheel) since the driving behaviour becomes
unpredictable otherwise.
1
Figure 13
1
Figure 14
53