Marshall CODE 50 Manuel D'utilisation page 22

GUITAR TUNER
Pressing the PRE FX and AMP Section Switches (#15 & #16 in this manual) together
accesses the guitar TUNER:
• Pluck a string and the note you are playing will display.
• Tune the string until the name of the note you wish to tune to appears on the screen.
• The bar will move to the left if the note is flat. The bar will move to the right if the note is
sharp.
• When the bar is dead centre, that string is tuned to the displayed note.
• Press EXIT/STORE to exit the Tuner.
FACTORY RESET
Performing a factory reset will return CODE's Presets back to when it was new.
Before performing a factory reset, be sure that you want to overwrite all of your personal
!
Presets.
To perform a factory reset:
• Power OFF the amplifier using the ON/OFF switch (#14 in this manual).
• Whilst holding down the AMP Section Switch, turn the power ON.
• The screen will display a notification that the amplifier is about to be returned to its
factory settings.
• If you are sure that you want to perform a factory reset, press and hold the EXIT/STORE
switch to confirm.
• If you do not want to restore the factory presets, pressing any other switch will cancel the
factory reset operation and boot the amplifier as normal.
ENGLISH
A: >>|<< A: >>|< A: >>|< A: >>|<