Cleaning And Storage; Troubleshooting - DS Produkte 02753 Mode D'emploi

EN
Thighs: Stand on one leg, bend the other one and grab your foot with your hand. Pull
it up to your buttocks and hold this position for around 5 – 20 seconds. Change sides.
Sit down on the fl oor, turn your knees to face outwards, place the soles of your feet to-
gether and pull towards your body. Place your hands around your ankles and press your
knees gently down to the fl oor with your elbows. Keep your back straight. Stay in this
position for around 5 – 20 seconds.
Back: Lie down fl at on your back, bend your right leg and place it over your left leg, your
hip twists but both shoulders remain on the fl oor. Stay in this position for around 5 – 20
seconds. Change sides.
Shoulders / back: Sit down cross-legged with a straight back, fold / clasp together your
hands and stretch your arms out above your head. Stretch your back. Stay in this posi-
tion for around 15 – 20 seconds.

Cleaning and Storage

PLEASE NOTE!
■ Do not use any caustic or abrasive cleaning agents or cleaning pads to clean the
device. These may damage the surfaces.
• Wipe the device and accessories with a damp, soft cloth and a little mild cleaning
agent if required. Then thoroughly dry them off .
• Store the device in a dry place that is protected from frost and direct sunlight and is
not accessible to children and animals.

Troubleshooting

If the device does not work properly, fi rst check whether you are able to rectify the prob-
lem yourself. If the problem cannot be solved with the steps below, contact the customer
service department.
Do not attempt to repair an electrical device yourself!
Problem
The device does not
work, the I / 0 main power
switch (2) does not light
up.
The device switches off
before the set workout
time has elapsed.
22
Possible cause
The connecting cable
is not connected to the
device and / or the plug
socket correctly.
The plug socket is defec-
tive.
There is no mains volt-
age.
The device has been
overloaded.
Solution
Check that the two plug
connectors fi t correctly.
Try another plug socket.
Check the fuse of the mains
connection.
Flip the I / 0 main power
switch (2) to position 0.
Wait a moment before it is
switched back on.