Cleaning - ZUMEX HORECA & FOOD Minex Manuel De L'utilisateur

MANUAL USUARIO MINEX 11/9/06 17:27 P gina 13
· Alarms Mode: The machine has stopped automatically because of several
causes, low voltage, over current, twirler blocked or feeder blocked. If this happens
the display indicates the origin of the problem by using following alarm codes:
EXAMPLE
ALARM
02
In order to start the machine after a security stop or alarm stop, it is necessary
to eliminate the cause (take out blocked oranges) and restore the three security
elements (cover, juice tray, peel bucket). Once this has been done push the ON/OFF
button and the machine will start the squeezing cycle.
Closed Open
Dismantle
Blade block position
24
ALARM 01 Low voltage
ALARM 02 Over current
ALARM 03 Twirler blocked
ALARM 04 Feeder blocked
Over current
Dismantling the twirler blade

4.3 CLEANING

Follow the next steps to clean correctly the machine
1- With the machine not working, disconnect it from the mains by pulling out
the socket. Never pull the cable.
2- Remove the front cover.
3- Dismantle the unit composed by twirler blade and support (fig. 5), turning
the selector (see diagram on previous page) clockwise to position
pull gently towards you. Warning! Handle this part with care to avoid cuts.
The support, twirler blade and blade block unit must always be assembled
and dismantled as one piece.
For more thorough cleaning, separate the parts as follows:
- After removing the unit from the machine, turn the selector to position
to remove the blade block.
- To remove the twirler blade, move the blade to a vertical position until the
marks on the blade and support coincide. In this position it should come
away easily.
4- Remove the peel ejector from its support (Fig. 6) and the pressing units
unscrewing the knobs that hold them. (Fig. 6).
5- Remove the peel bucket and the jar (Fig. 7).
6- Remove the juice tray and the filter and, after it, take apart the drip tray
(Fig. 8).
7- Remove the faucet of the juice tray, following the numbered steps.
2
• All the parts, except for the cover AND THE PISTON AND RUBBER RING OF THE
FAUCET can be washed with a dishwasher.
• Clean the juicing area and cover with a soft cloth, dampened with water and soap
suitable for tableware.
• Next, rinse with water to ensure there is no soap.
and
EN
3
1
25