Cleaning; Things To Remember - ZUMEX Speed Manuel De L'utilisateur

Cleaning

Zumex recommends cleaning the machine at least once or twice a day, depending on how
much it is used in order to maintain optimal food hygiene conditions.
For correct cleaning you must follow the steps below:
All of the plastic components are dishwasher safe, apart from the Speed Pro Cooler Juice
A
Tank (70.6).
Do not put the SS Tap Up (44U), SS Tap S +plus (44+) in the dishwasher as it can lead to
B
premature oxidation of the stainless steel.
All models
1
Unplug the machine from mains.
2 For assembly and disassembly check the relevant section for each component found in the
Assembly and Disassembly section.
3 Remove Side Outlets.
Remove the Cover.
4
5 Follow the instructions for the Assembly/disassembly of the various components dependent
on model.
Speed Pro Basic, Speed Up, Speed Up All-in-One,
Speed Cooler Podium
6 Remove the blade-holder, pulling towards you from the handle.
Warning! Handle this part with great care as you could cut yourself.
!
7 Extract the peel ejectors from their supports (Fig. 1)
8 Remove the pressing units by pairs, previously unscrewing the securing knobs (Fig. 1).
9 Remove the juice containers and filters; see the respective Figure according to model according
to section Unpacking and start-up.
Speed S +plus, Speed S +plus All-in-One,
Speed S +plus Tank All-in-One
Remove the 1Step Extraction Unit (19+).
6 +
There are two possibilities when cleaning:
• Complete cleaning: once the unit has been removed from the machine, get rid of extra
pulp and peel if there is any washing it with water and if necessary a mild soap. The whole
unit is also dishwasher safe.
• Deep cleaning: all of the components can be removed and can be cleaned individually.
Zumex recommend this type of deep cleaning at least once a week depending on how
much usage the machine gets.
7 + Remove the Blade holder S +plus (9+) and clean it carefully taking care not to hurt yourself.
8 + Remove the PulpOut System (42+).
9 + To clean all of the components of the unit they should be removed and washed individually, this
can be done by hand or in the dishwasher.

Things to remember

C Cleaning non-detachable elements. Use a damp cloth with lukewarm water and soap, and
then rinse.
D
Remember that although some parts are similar they must be mounted on different sides.
E Transparent parts and dish-washers: these parts can be washed in the dish-washer, although
you must make sure you use the correct soap, salt and brightener so that the parts remain
shiny and transparent.
F In models with tap: Unscrew the tap from the container, separate the button from the body
to clean thoroughly. Remove taps as indicated in the sections: SS Tap Up (44U), SS Tap S +plus
(44+), Tank Tap (55) of Assembly and detachment of components according to model.
G In models with the Drain&Clean System, Zumex recommends cleaning the inside of the tube
with a large brush (Fig. 7.1) at the start of the feeding tube, at least once a week. This process
will avoid any possible blockages.
Feeding tube: Whether or not your machine has the Drain & Clean System, it is advisable to
H
disassemble the turntable from the feeder for complete removal of wax and debris.
I For any area with difficult cleaning Access, we recommend using the brush (Fig. 1) included in
the machine.
EN
63