Cleaning - ZUMEX SPEED PRO Série Manuel De L'utilisateur

MENU DIAGRAM
MAIN MENU
BASIC
AUTOMATIC
015.030
PIN
****
OK
MENU MENU MENU MENU
1.Language 2.Pin 3.Counter 4.Mode
OK OK OK OK
1
LANGUAGE . Select the language
to operate the machine.
2
PIN. See or change the PIN.
3
COUNTER. See total or partial
counter of the machine.
4
MODE. Select the working mode:
automatic or professional.
MENU MENU MENU MENU
5. W aste limit 6.Calibrate 7.State 8.Contrast
OK OK OK OK
5
WASTE LIMIT. Activate a warning to know
when to empty the waste bin.
6
CALIBRATION. To calibrate the machine
for correct count.
7
STATUS. Access the different anomalies that
a machine stoppage may have caused.
8
CONTRAST. To adjust the brightness level on
the display.

CLEANING

Zumex recommends cleaning the machine at least once or twice a day, depending on how much it is
used in order to maintain optimal food hygiene conditions.
For correct cleaning you must follow the steps below:
1 Unplug the machine from mains.
2 Remove Side Outlets.
Remove the cover.
3
4 Remove the blade-holder, pulling towards you from the handle.
Warning! Handle this part with great care as you could cut yourself.
5
Extract the peel ejectors from their supports (Figure 1).
6 Remove the pressing units by pairs, previously unscrewing the securing knobs (Figure 1).
7 Remove the juice containers and filters; see the respective Figure according to model according
to section: UNPACKING AND START-UP.
8 In models with tap:
Unscrew the tap from the container, separate the button from the body to clean thoroughly.
Remove taps as indicated in the sections: SS tap (44), Tank tap (55) of ASSEMBLY AND DETACHMENT
OF COMPONENTS ACCORDING TO MODEL.
9
In models with Drain&Clean System. You can carry out a light cleaning by emptying a jug of warm
water into the feeder.
Whether your model has the Drain&Clean System or not, it is advisable to remove the feeder, to
completely eliminate wax.
Cleaning non-detachable elements. Use a damp cloth with lukewarm water and soap, and then
10
rinse.
11 Remember that although some parts are similar they must be mounted on different sides.
12
Do not wash Speed Pro Cooler machine tank parts in the dish-washer.
13 Transparent parts and dish-washers: these parts can be washed in the dish-washer, although you
must make sure you use the correct soap, salt and brightener so that the parts remain shiny and
transparent.
51