Configuration - ZUMEX SPEED PRO Série Manuel De L'utilisateur

SPEED PRO COOLER: COOLER UNIT
Switch the cooler unit on by activating the switch on the left of the juice outlet. You can adjust the
juice temperature with the control situated on the right. Turn in clockwise direction for colder juice
and anti-clockwise direction for less cold juice.
Activate the tank lever to fill a glass or jug.
Important! Remember to switch off the Cooler unit (70) when you switch off the main machine to
avoid unnecessary consumption.

CONFIGURATION

Your Zumex Speed Pro juicer enables you to set parameters to your liking.
Use the electronic device to choose and program the operating mode of your machine. With it, you
can control attributes and functionalities following the MENUS enclosed.
To enter the MENU press the STOP and MODE buttons for at least 2 seconds and enter the default PIN
(0000).
After entering the menu, you can set:
LANGUAGE: You have a choice of 23 available languages.
PIN: See or change the current PIN so that nobody else can change the machine parameters.
COUNTER: See total or partial counter of the machine. Reset the partial counter, visible on the
main screen. To reset the machine counter, press STOP + START for 3 seconds until the counter
indicates 0000000.
Ascending or descending CREDIT: You can program the machine credit so the machine can be
stopped, in ascending order or descending order, until the machine has been programmed again.
MODE LOCKING SYSTEM: You can get the machine to only work in Automatic or Professional
and even so the number of oranges or volume to be squeezed cannot be changed, so that it only
squeezes the quantity set by you.
MANUAL MODE (HELP MODE): Some machine models have an actuator or an auxiliary operating
sensor. This can be annulled by selecting the MANUAL mode. [Self Service Model: SS tap. Tank (44)
and Cooler Model: Level detector (56)].
WASTE LIMIT: You can activate an alarm so that the machine will stop when the desired number of
oranges has been squeezed. Thus, you will know when the waste bin has to be emptied.
CALIBRATION: You can calibrate the machine to guarantee that the machine count is correct at
all times.
MACHINE STATUS: You have access to the different anomalies that a machine stoppage may have
caused.
CONTRAST: You can adjust the brightness level on the display.
Remember! Within the CLIENT MENU mode:
"Short OK" to go down a level.
"Long OK" to go up a level.
"Long OK" to save data (The save symbol will appear).
To exit CLIENT MENU, you must go up the same number of levels you have gone down.
49