Assembly And Detachment Of Components According To Model - ZUMEX SPEED PRO Série Manuel De L'utilisateur

SPEED PRO TANK PODIUM, SPEED PRO TANK PODIUM DRAIN&CLEAN SYSTEM
The following components come loose and must be mounted if necessary: Right cover side outlet
(2), Left cover side outlet (3), Power cable (15), Cable protector (16), SS/Tank filter (42), Pulp sweeper
(43), Tank juice container (50), Tank sub-filter (51), Tank/Cooler buoy (52), Tank (53), Shaker (54), Tank
Tap (55).
See Figures 1 and 5. See section SS/TANK STAND (90) for information about your machine stand.
SPEED PRO COOLER PODIUM
The following components come loose and must be mounted if necessary: Right cover side outlet
(2), Left cover side outlet (3), Power cable (15), Cable protector(16), Plastic juice container (30),
Plastic inner filter (31), Plastic juice filter (32), Cooler unit (70), Tank/Cooler buoy (52).
See Figures 1 and 6. See section COOLER STAND (100) for information about your machine stand..
DRAIN&CLEAN SYSTEM (80)
If you have purchased a Drain&Clean System model, your machine will have a drain that goes from
the feeder to the waste bin inside the machine.
See Figure 7.1.
SELF SERVICE STAND/TANK PODIUM STAND (90)
COOLER STAND (100)
You will receive it in a different package, depending on the machine model you have received.
All the stand components can be found inside the stand.
ASSEMBLY AND DETACHMENT OF
COMPONENTS ACCORDING TO MODEL
1. ASSEMBLY
SPEED PRO COVER (1)
Line up the 3 holes of the cover with the 3 shaft knobs. Turn these 90º in clockwise direction
(Figure 10).
RIGHT COVER SIDE OUTLET (2), LEFT COVER SIDE OUTLET (3)
Make sure that the side outlets are fully mounted and correctly in place (Figure 10).
The Side Outlets are not the same. Make sure you place the respective Side Outlet on the correct side.
Line up the lower part of the Side Outlet and turn towards the cover until the clip clicks in.
LOWER PRESSING UNIT (4), UPPER PRESSING UNIT (5)
Place the pressing units in the shafts (Figure 1).
Always mount the lower and upper pressing units of the same side at the same time to make it
easier to position them.
INJECTION PLASTIC SECURING KNOB (6)
Screw in the knobs to secure the pressing units and the feeder plate (Figure 1).
LEFT PEEL EJECTOR (7), RIGHT PEEL EJECTOR (8)
Place the ejectors on the respective side on the guides (Figure 1).
BLADE-HOLDER (9)
Place the blade carefully on its guide and push inwards (Figura 1).
35