Assembly And Detachment Of Components According To Model - ZUMEX Speed Pomegranates Manuel De L'utilisateur

Assembly and detachment of
components according to model
1. Assembly
Cover (1)
Line up the 3 holes of the cover with the 3 shaft knobs. Turn these 90º in clockwise direction
(Fig. 10).
Right cover side outlet (2), Left cover side outlet (3)
Make sure that the side outlets are fully mounted and correctly in place (Fig. 10).
The Side Outlets are not the same. Make sure you place the respective Side Outlet on the
correct side.
Line up the lower part of the side outlet and put the upper part into place, turn the knob 90º
to lock it into place.
Lower pressing unit (4), Upper pressing unit (5)
Place the pressing units in the shafts (Fig. 1).
Injection Plastic Securing Knob (6)
Screw in the knobs to secure the pressing units and the feeder plate (Fig. 1).
Left peel ejector (7), Right peel ejector (8)
Place the ejectors on the respective side on the guides (Fig. 1).
Blade holder (9)
Place the blade carefully on its guide and push inwards (Fig. 1). Thread the securing knob.
Feeder basket (13)
The feeder basket can be removed and re-attached facing guides and making a slight
movement until it stops (Fig. 1).
Feeder basket door (14)
The feeder basket has an easy-to-open door to make it easier to fill the basket up with
pomegranates (Fig. 1).
Power cable (15)
Check cord is plugged in the machine and protected with cord retainer (Fig. 1).
Protector cable with 3 screws (16)
Check protector holds cable with three screws (Fig. 1).
Tray bolt (18)
This component only has to be handled if a spare SS Juice container (40) is requested (Fig.
1). After inserting the spare container, adjust the bolt from the rear to adjust the container
position.
Self Service Juice container (40)
Line up the container in the main opening. At the same time, line up the two side lugs at
the ends of the container and press. Pressing the side buttons may help mount it (Fig. 12).
Self Service Sub-filter (41)
Place on the inside of the juice extraction container (Fig. 4U).
EN
21