Detecting Faults And Problems - ZUMEX MULTIFRUIT Manuel De L'utilisateur

Detecting faults and problems

FAULT POSSIBLE CAUSE
The machine is
unplugged
No power reaches
the plug
The fuse has blown
THE MACHINE IS
NOT WORKING.
LED OFF
The cover is not
placed correctly
The handle is not
placed correctly
Internal damage
The waste bucket is
THE MACHINE
separated from the
DOESN'T WORK THE
machine body
LED IS FLASHING.
(for 115V machines
only)
Internal damage
CORRECTIVE MEASURE
Connect the machine
to the power supply
Check the plug
Replace (the machine
includes a spare one
next to the first one).
Figure 1 detail
Make sure that it is placed
correctly
Make sure that it is placed
correctly
Please contact Technical
Support
Put the waste bucket
next to the machine,
in the correct position
Please contact Technical
Support
FAULT POSSIBLE CAUSE
THE MACHINE
Anomaly inside the
WORKS BUT
machine
THE LED IS OFF
THE MACHINE
OFTEN GETS
Not enough voltage
BLOCKED WHEN
JUICING
THE MACHINE
Unbalanced filter
VIBRATES A LOT
because of the fruit
WHEN JUICING
The cover is full of
waste
THE JUICE HAS
TOO MUCH PULP
Blending soft fruit
on speed 2
THE ANTI-DRIP
The juice has pips or
OUTLET GETS
too much pulp
OBSTRUCTED
IMPORTANT
Always unplug the appliance from the power supply before carrying out any operations to unblock it
or remove any obstructions. If, after following the troubleshooting advice contained in this manual, the
appliance still does not work, contact the Technical Support Service.
ZUMEX SERVICE Tel. +44 2035191292 · service.uk@zumex.com
EN ES
CORRECTIVE MEASURE
Please contact Technical
Support
Check that the voltage
is the one stated in the
manual
Disassemble the filter
and clean it
Disassemble the cover
and clean it
Use speed 1 for soft fruit
and speed 2 for hard fruit
Remove the anti-drip
and clean it.
Use speed 1 for soft fruit
and speed 2 for hard fruit
23 23