Operation - ZUMEX MULTIFRUIT Manuel De L'utilisateur

Operation

Preparing the fruit and vegetables:
· Always wash fruit and vegetables before processing them.
· Peel fruits with inedible or thick skins, such as melons, mangoes
or kiwis, before juicing.
· Stone large-stoned fruits, such as peaches, plums or cherries,
before juicing.
· Given that the diameter of the fruit feeding tube is 75mm.,
larger fruits should be cut up into smaller pieces. When the pieces
of fruit are very much smaller than the feeding tubeis diameter,
you may process several together.
· Before using the multi-juicer for the first time, we recommend
cleaning it. See "Cleaning" section.
Operation
Switch the machine on by putting the rear power switch on "I" (Fig 1). Place the
1
waste bucket in the correct position, next to the rear of the machine. Take care! If
your machine works at 115V and the LED flashes, the container has been placed
incorrectly. Return to the "0" position and place the waste container on the rear
wall of the blender. If the flashing continues, please get in contact with Technical
Support (Fig 2).
Place a container under the juice outlet and select the required speed ( 1 or 2 ).
2
In order to get the highest performance, the speed 1 is the one for soft fruit (e.g.
apples, pineapples, watermelon, strawberries, grapes). The speed 2 is perfect for
hard fruit or vegetables such as carrots, broccoli, celery, beetroot, etc. Once you
have selected the speed, the machine will start to operate and the LED will stay
on. (Fig 3).
3
1
4
5
Soft fruits and
vegetables
!
2
!
Hard fruits and
vegetables
!
Insert the fruit in the tube and press it with the pusher. You'll get juice instantly.
To stop the machine, turn the switch to the position "0". Remember that the
machine will remain on stand-by until the rear power switch is "0" position.
To prevent the juice from dripping when not blending, activate the anti-drip
tap by turning it 180º (Fig 4).
NOTA: After the machine remains on "0" for a longtime, the internal
cooling fan may start up and will make a quiet noise. This operation is
completely normal.
If the locking handle is lifted or the peel bucket removed during operation,
the appliance will automatically stop (for 115V machines only). The
appliance will also not work if the cover and locking handle are assembled
without fitting the stainless steel tank.
If there is a power cut whilst the appliance is running, it will not
automatically start up again once the power comes back on. To start
up the machine, put the selector and the rear power switch on the "0"
position. After re-connecting it or restoring the electrical power supply,
you must start up the switching on process, retuning to step 1.
To avoid accidents do not manipulate the machine in order to make it
work without the security devices: handle, cover and peel bucket (for 115V
machines only).
Attention! Whenever there is an emergency stop, once the problem
is solved, you must put the speed selector on "0" and then select the
required speed.
EN ES
15 15