Operation - ZUMEX Multifruit Manuel De L'utilisateur

Operation

Preparing the fruit and vegetables
• Always wash fruit and vegetables before processing them.
• Peel fruits with inedible or thick skins, such as melons, mangoes or kiwis, before juicing.
• Stone large-stoned fruits, such as peaches, plums or cherries, before juicing.
• Given that the diameter of the fruit feeding tube is 75mm., larger fruits should be cut up into
smaller pieces. When the pieces of fruit are very much smaller than the feeding tubeís diameter,
you may process several together.
Operation
Step 1: Switch the machine on by putting the rear power switch on 'I'. Place the waste bucket in
the correct position, next to the rear of the machine. Take care! If your machine works at 115V and
the LED flashes, the container has been placed incorrectly.Return to the Stand-By position (Fig.3)
and place the waste container on the rear wall of the blender. If the flashing continues, please get
in contact with Technical Support.
Step 2: Place a container under the juice outlet and select the required speed ( · or · · ). In order
to get the highest performance, the speed · is the one for soft fruit (e.g. apples, pineapples,
watermelon, strawberries, grapes). The speed · · is perfect for hard fruit or vegetables such as
carrots, broccoli, celery, beetroot, etc. Once you have selected the speed, the machine will start
to operate and the LED will stay on.
Step 3: Insert the fruit in the tube and press it with the pusher. You'll get juice instantly.
Step 4: To stop the machine, turn the switch to the position Standby. Remember that the machine
will remain on Standby until the rear power switch is '0' position.
Step 5: To prevent the juice from dripping when not blending, activate the anti-drip tap by
turning it 180º (fig. 4).
NOTE After the machine remains on Standby for a long time, the internal cooling fan may start up and
will make a quiet noise. This operation is completely normal.
English Instructions for use
23