Detecting Faults And Problems - ZUMEX ESSENTIAL Manuel De L'utilisateur

6. DETECTING FAULTS AND PROBLEMS

• ALL MODELS
FAULT POSSIBLE CAUSE
The machine is Machine is not on
not operating No voltage
Top is not placed correctly
Juice container incorrectly placed Ensure it is placed correctly
Drums are blocked
Faulty safety detectors
Faulty ON/OFF switch
Faulty circuit
Machine blocks often
Not enough voltage
when juicing
Faulty circuit
Drums are not
Internal fault
synchronized
Peel ejector is broken
Peel ejector is incorrectly placed
Motor is running but pressing Internal fault
units are not running
Tap is blocked Juice has pulp or seeds
Machine stops after a
Not enough ventilation
short period of time
Too much power
• ONLY DIGITAL MODELS
FAULT POSSIBLE CAUSE
Light nº5 does not turn on
No power
(see fig. 6)
Light nº 4 turns on Safety detectors are not
(see fig. 6)
• ONLY Zumex Essential Autostart
FAULT POSSIBLE CAUSE
The machine does not start Obstructed Photocells
Damaged Photocells
Photocells are off
Main card connection
error
Damaged leds
"ERR MOTOR" message
Motor is blocked or there is
too much power
Motor is disconnected
Blown fuse
Faulty motor
IMPORTANT: The machine must be disconnected before trying to unblock it. If these solutions do not work, please contact
the Technical Support Service.
32
All manuals and user guides at all-guides.com
SOLUTION
Connect it
Check the socket
Ensure it is placed correctly
Disconnect the machine and
unblock the drums
Contact the Technical support service
Contact the Technical support service
Contact the Technical support service
Check voltage and see if it matches
that described in the manual
Contact the Technical support service
Contact the Technical support service
See the manual for correct placement
instructions
Contact the Technical support service
Remove the top part of the tap and clean
Ensure the ventilation grids of
the machine are not blocked
Contact the Technical support service
SOLUTION
Check the unit's connection.
If you cannot find the problem,
contact the Technical support service
Check the container and/or top
to see if they are placed correctly
SOLUTION
Clean
Contact the Technical support service
Check the connection
Contact the Technical support service
Disconnect the unit and unblock
Contact the Technical support service
Contact the Technical support service
Contact the Technical support service
ZUMEX, MÁQUINAS Y ELEMENTOS S.A.
Pgno. Inds Moncada II · c/ La Closa, 16
46113 Moncada, Valencia, España
Tfno: +34 961 301 251 · Fax: +34 961 301 255
www.zumex.com · zumex@zumex.com
EN
33