Automatic Mode; Professional Mode - ZUMEX Speed Pomegranates Manuel De L'utilisateur

Loading the feeder
To load the machine feeder with pomegranates, you can open the Feeder basket (14) door and
partially empty the box of pomegranates into it. Close the door and finish filling the basket.
Juice extraction unit
Make sure that all the elements that permit cutting the pomegranate, extracting the juice and
collecting it are mounted on the machine. To do this, consult the machine model purchased on the
diagram indicated in section: Unpacking and start-up. Assembly and detachment of components
according to model.
Check the state of the containers and filter to guarantee quality juice.
Juicing
You have a machine with:
• Automatic PulpOut System (42+), the pulp and any seeds will be expelled from the left hand side
of the machine.
• SS Tap Up (44U), read the instructions for use of the Self Service tap in section Assembly and
detachment of components according to model.
Waste area
Make sure that the elements that collect the pomegranate peel are correctly positioned.
Check if the tanks are getting full, to prevent the peel from flowing over.
You can also use the new function, Waste Limit, which enables you to programme an alarm so
that the machine will stop when the waste bin is full.
You can select the number of pomegranates you want to squeeze before the alarm sounds. Once
you have squeezed the amount of pomegranates programmed, the machine will stop and a
warning will appear on the display so that the operator knows the waste bin has to be emptied.
To switch the alarm off, press the OK button for approximately 2" until it comes to a stop.
Remember!
"Short OK", it doesn't switch off.
"Long OK", double "beep", to switch off.
To switch the alarm off permanently, enter the Waste Limit section of the CLIENT MENU.
If the machine is turned off or unplugged, the waste alarm will be eliminated and it will start from
zero again.
Machine operation
General
The machine can operate in Professional or Automatic mode in all the models. To shift from one
mode to another keep the Mode button pressed for a few seconds. Whenever you change from
Automatic to Professional, you will be asked to program the number of pomegranates to be
squeezed. If you do not want to change the quantity, just wait a few seconds or quickly press the
OK button. If you wish to modify the quantity, press the + - buttons to select the quantity, and
then the OK button until the Saved symbol appears.
The START button is not active. It is only active in MANUAL mode.

AUTOMATIC MODE

Control from SS Tap Up (44U).
Uninterrupted operation,
whilst the tap is pressed.

PROFESSIONAL MODE

Control from tap whilst pressed.
Minimum number of pomegranates 1
Maximum number of pomegranates
12
Default value
3
MANUAL MODE (If the tap does not work)
The START button becomes active in Manual mode.
In manual mode, it is still possible in Automatic
and Professional mode from the keypad.
"AUTOMATIC" MANUAL
Uninterrupted operation.
"PROFESSIONAL" MANUAL
1
Minimum number of pomegranates
Maximum number of pomegranates 12
Default value
3
The STOP button is always operative.
EN
27