ZUMEX SPEED PRO Série Manuel De L'utilisateur page 20

FEEDER BASKET (13)
The feeder basket can be removed and re-attached facing guides and making a slight movement
until it stops (Figure 1).
FEEDER BASKET DOOR (14)
The feeder basket has an easy-to-open door to make it easier to fill the basket up with oranges
(Figure 1).
POWER CABLE (15)
When you receive the machine, you must connect the cable to the machine base (Figure 1).
CABLE PROTECTOR with 3 screws (16)
Fit to prevent the cable from being accidentally removed (Figure 1).
SS/TANK TRAY GASKET 6.3 x 3.5 (17)
If required, this gasket can easily be removed for cleaning and fitted back in by hand (Figure 1).
TRAY BOLT (18)
This component only has to be handled if a spare SS Juice container (40) or Tank juice container (50)
is requested (Figure 1). After inserting the spare container, adjust the bolt from the rear to adjust
the container position.
PEEL BUCKET (20)
Place the peel buckets under the side outlets of the cover (Figure 2 or 3 depending on model).
DRIP TRAY (21)
Place under the juice outlet (Figure 2 or 3 depending on model).
PLASTIC JUICE CONTAINER (30)
Make sure that the sealing gasket is correctly mounted on the container (Figure 11). Then place
the container in the machine. Line up and place under the container on the four lugs that you will
see on the machine (Figure 2).
PLASTIC INNER FILTER (31)
Place on the inside of the juice extraction container (Figure 2).
PLASTIC JUICE FILTER (32)
Place on the inside of the juice extraction container (Figure 2).
SS JUICE CONTAINER (40)
Line up the container in the main opening. At the same time, line up the two side lugs at the ends
of the container and press. Pressing the side buttons may help mount it (Figure 12).
SS SUB-FILTER (41)
Place on the inside of the juice extraction container (Figure 3).
SS/TANK FILTER (42)
Line up the 2 rear openings with the 2 inner rear lugs of the container. Let the filter fall forwards
and line up the front openings with the front lugs.
The filter rests on the SS juice container (40) (Figure 3) or Tank juice container (59) (Figure 5).
PULP SWEEPER (43)
Make sure that the inner guide of the pulp sweeper is correctly mounted (Figure 13).
You can extract or insert the pulp sweeper by turning the side catch 90º (Figure 13).
Note: Make sure that the catch is in its closed position, so that the pulp sweeper can never
accidentally drop from the filter.
37