Cleaning - ZUMEX Essential Manuel De L'utilisateur

Total counter: This shows you all the oranges consumed throughout the life
of the juicer, this counter cannot be deleted.
On the TECHNICAL SERVICE menu select COUNTERS > TOTAL COUNTER
and press ON to confirm your selection. You can view the number of oran-
ges on the screen. Move up to the upper menu by pressing OFF.
Discounter: This allows you to programme a given no. of oranges and
gradually consume oranges from this total. On the TECHNICAL SERVICE
menu select COUNTERS > DISCOUNTER and press ON to confirm your
selection. Enter your PIN (Remember: Select each digit using the cursors
, press OFF to move from digit to digit and ON to confirm the
password) and you will enter the discounter menu. Programme each digit
of the discounter using the cursors
to move on to the next one and repeat this action for each digit; on the
last digit press ON and the selection will be memorised automatically.
Then select whether you want the discounter to be visible or not on the
main menu (visible/concealed option). Return to the menu, pressing OFF
repeatedly.
Once the discounter is at zero, the juicer will stop until a new sum
of oranges is loaded or a change is made to the counter function,
entering the "MAIN COUNTER" menu and confirming by pressing ON.
When the visible discounter has been programmed, a 'D' will appear
on the normal operating screen in front of the counter digits. If
the concealed discounter has been programmed, no figure will be
displayed.
and after each digit press OFF

Cleaning

Zumex recommends cleaning the machine at least once or twice a day, depending
on how much it is used in order to maintain optimal food hygiene conditions.
Zumex recommends using Zumex Citric Active Detergent
designed to clean citrus juicers with a high descaling effect for wax and pulp.
For correct cleaning you must follow the steps below:
WARNING!
!
Turn the machine off at the mains before cleaning process.
Essential Basic, Essential Pro
Disassemble the container (Fig. 10) by removing it using both hands and
1
pulling it outwards. To assemble it again, hold the container with both hands
and position it on the guide rails of the cover and push it until it is fully inserted.
!
Important: If the container is not correctly assembled, the machine will not
be activated. If the juice container contains a filter and juice residue; handle
with care to avoid accidentally spilling juice or dropping the filter.
2 Disassemble the filter by pulling the tab.
Empty its contents and place it upside down on a flat surface.
3
Press the plastic pins of the tap and remove the pivots inserted in the container
4
(Fig. 11). Remove the back part first and then remove the front part. To
assemble, follow these steps in reverse order: first, insert the front part into the
container, then press the pins until the pivots fit into the holes of the container.
Lightly pull the faucet to check that it has been correctly inserted.
5 Remove the front cover by opening the side catch (Fig. 14). Turn the cover
90º to the right until it is outside the feeder. Pull upwards until it is released
from the hinges. To assemble it again, hold the cover firmly with both hands
and mount it in its fully open position, taking care to insert the three hinges
into their holes. Close the cover and lock its position.
!
Important: Always disassemble the container before removing the cover.
Do not remove the cover until it is in its fully open position. Avoid carrying
weight on the cover as this could strain the hinges. Ensure that the cover is
correctly inserted in its three hinges before closing it.
EN
, which is specially
TM
31