Technical Service - ZUMEX Essential Manuel De L'utilisateur

Technical Service

The Zumex Essential Pro and Versatile Pro juicers provide you with the in-
formation you need for correct unit maintenance. They are also fitted with
a squeezed orange counter which can be configured in this mode. Press the
MENU key for a few seconds to enter the menu and select TECHNICAL SER-
VICE, press ON to confirm your selection and OFF to return to the previous
menu.
Serial number: This shows you your juicer's serial number which is essential for
any TECHNICAL SERVICE consultation.
On the TECHNICAL SERVICE menu select SERIAL NUMBER and press ON to
confirm your selection. You can see the serial number on the screen. Return to
the previous menu by pressing OFF.
Voltage: This shows you the mains voltage at the time of the consultation,
vital for any Technical Assistance Service.
On the TECHNICAL SERVICE menu select VOLTAGE and press ON to confirm
your selection. You can view the voltage on the screen. Return to the previous
menu, pressing OFF.
Calibration: This shows you the calibration value of your machine which must
be adjusted in exceptional cases when the counter is not counting correctly.
This information is vital for any Technical Assistance consultation. It also lets
you change the values manually. This procedure must only be carried out at
the indication and with the aid of an authorised Technical Assistance Service.
Calibration value: On the TECHNICAL SERVICE menu select CALIBRATION
> CALIBRATION VALUE and press ON to confirm your selection. You can
view the calibration number on the screen. Return to the menu, pressing
OFF.
Offset Value: On the TECHNICAL SERVICE menu select CALIBRATION
> OFFSET VALUE and press ON to confirm your selection. You can view the
offset number on the screen. Return to the menu, pressing ON.
Calibrate: Select CALIBRATE and press ON. Next, set your PIN number and
press ON. The machine will ask for confirmation: 'Calibrate?', press 'ON'
to confirm the automatic calibration. The machine will then carry out said
calibration and display the adjusted calibration value. Return to the menu,
pressing OFF.
This option must only be carried out under the supervision of the Technical
Service and when it has been specifically indicated.
Pin: Your juicer has a password so you can access the counters and modify
configuration parameters. The standard programmed PIN is 0000 but you
can personalise this PIN. On the TECHNICAL SERVICE menu select PIN and
press ON to confirm your selection. If this is the first time you have changed
your PIN, the standard PIN 0000 will appear and press ON; if you have already
programmed a password previously, enter the old password, use the cursors
to select each digit, press OFF to move from digit to digit and ON to
confirm the password. Upon entering the correct PIN the "New PIN" screen will
appear. Programme the new password, select each digit with the cursors
press OFF to move from digit to digit and ON to confirm the new PIN.
If you forget the Pin number programed, you will be required to reset
machine's MENU. In order, to do that, enter CONFIGURATION press
and while pressed, press button simultaneously.
Counters: You can control the counter and discounter of your juicer. The
counter allows you to establish the no. of oranges squeezed, the discounter
function allows you to programme a given no. of oranges and gradually
consume oranges from this total.
Partial counter: This shows you the no. of oranges consumed and it can be
set to zero. On the TECHNICAL SERVICE menu select COUNTERS > PAR-
TIAL COUNTER and press ON to confirm your selection. Enter your PIN (Re-
member: Select each digit with the cursor
digit to digit and ON to confirm the password). You can view the number
of oranges squeezed on the screen. To set the counter to zero press
confirm using ON and on the machine display you will see that the counter
has been set to zero. Return to the menu, pressing OFF repeatedly.
EN
,
button,
, press OFF to move from
and
29