Elevation Kit - ZUMEX Essential Manuel De L'utilisateur

Elevation Kit

This Zumex machine has an Elevation Kit to make it easier to clean the surface
where it is located. Elevation Kit ref. 05230* is not included in this model, it is
available in the machine accessory catalogue.
This Kit must be mounted according to the following instructions:
Components
Installation
The machine comes prepared for this Kit to be simply and quickly installed.
1
Place machine in assembly position.
Carefully place the machine on one of its sides, previously protecting this
area to prevent damage to the machine. This operation must be carried
out between two people, so that the base of the machine is in view,
facilitating the work process.
Legs 4
Adhesive felt disc 4
Screw-in stud 4
2
Fit the Elevation Kit legs.
There are four holes on the base of the machine, where the legs go. The
legs are supplied with some screw-in studs that are already fitted into the
ends of the legs. We must fully insert them into the holes (A) on the base
and then screw the legs in as far as they will go. Once this operation has
been carried out with all four legs, these can be mounted and removed
when required without the screw-in studs coming out of their housing.
A
3
Put the machine back into its working position.
Carefully stand the machine back up again leaving it in its working
position.
EN
37