Cleaning - ZUMEX Versatile Pro Manuel De L'utilisateur

Summary of Zumex Essential Pro and Versatile Pro Operating Modes
Serial number New Pin
Voltage
Calibration
Pin
Counters
Serial number Partial Counters
Total Counter
Voltage
Calibration Discounter
Pin
Counters
Partial Counters Total Counter
Total Counter
Discounter
76
Partial Counters
Total Counter
Discounter
Partial Counters Delete ? Partial Counters
10 0
Discounter
Visible
Concealed
000000
Visible
Concealed

Cleaning

Zumex recommends cleaning the machine at least once or twice a day, depending
on how much it is used in order to maintain optimal food hygiene conditions.
Zumex recommends using Zumex Citric Active Detergent
designed to clean citrus juicers with a high descaling effect for wax and pulp.
For correct cleaning you must follow the steps below:
All models
WARNING!
!
Turn the machine off at the mains before cleaning process.
1 Disassemble the container (Fig. 10) by removing it using both hands and
pulling it outwards. To assemble it again, hold the container with both
hands and position it on the guide rails of the cover and push it until it is
fully inserted.
! Important: If the container is not correctly assembled, the machine will not
be activated. If the juice container contains a filter and juice residue; handle
with care to avoid accidentally spilling juice or dropping the filter.
2
Disassemble the filter by pulling the tab.
3
Empty its contents and place it upside down on a flat surface.
4 Press the plastic pins of the tap and remove the pivots inserted in the container
(Fig. 11). Remove the back part first and then remove the front part. To
assemble, follow these steps in reverse order: first, insert the front part into the
container, then press the pins until the pivots fit into the holes of the container.
Lightly pull the faucet to check that it has been correctly inserted.
5
Remove the front cover by opening the side catch (Fig. 14). Turn the cover
90º to the right until it is outside the feeder. Pull upwards until it is released
from the hinges. To assemble it again, hold the cover firmly with both hands
and mount it in its fully open position, taking care to insert the three hinges
into their holes. Close the cover and lock its position.
!
Important: Always disassemble the container before removing the cover.
Do not remove the cover until it is in its fully open position. Avoid carrying
weight on the cover as this could strain the hinges. Ensure that the cover is
correctly inserted in its three hinges before closing it.
EN
, which is specially
TM
27