ZUMEX Versatile Pro Manuel De L'utilisateur page 16

Essential Basic, Essential Pro
6 Remove the blade holder (Fig. 7) by pulling it towards you using the handle.
WARNING!
handle this piece very carefully as you could cut yourself.
7
Pull the ejectors out until it is completely free from the machine (Fig. 8). To
assemble them again, place the ejectors on the corresponding side and insert
them onto the knobs. Push the ejector until the blade is fully inserted into the
lower pressing unit and the channel makes contact with the second knob.
! Important: Remove the ejectors before removing the pressing units of the
juicer. If the ejector is not correctly installed as indicated above, the part
may be damaged when the machine is in operation.
8 Remove the pressing units in pairs, after having unscrewed the knobs that
hold them in place (Fig. 9).
Versatile Pro
6 Remove the 1Step Kit (Fig. 15-16) from the machine. First, check the
assembly and disassembly instructions in the following section 1Step
Extraction Kit.
There are two possibilities when cleaning:
• Complete cleaning: once the unit has been removed from the machine,
get rid of extra pulp and peel if there is any washing it with water and if
necessary a mild soap. The whole unit is also dishwasher safe.
• Deep cleaning: all of the components can be removed and can be
cleaned individually. Zumex recommend this type of deep cleaning at
least once a week depending on how much usage the machine gets.
7
Remove the Blade holder (9) and clean it carefully taking care not to hurt
yourself.
• The plastic parts of the squeezing system are suitable for cleaning in a
dishwasher.
• We do not recommend cleaning the cover and the juice container using the
dishwasher. Follow this recommendation to increase their durability. To clean
both parts, use a soft cloth soaked in water and Citric Active or food-grade
soap. Under no circumstances should you use abrasive or anti-lime products.
• The juice tap and tray must be separated for their correct cleaning, preventing
dirt from accumulating between both. The tap may be cleaned in the dishwasher.
• When cleaning the squeezing and cover area you should use a soft cloth
dipped in water and washing-up liquid. Then rinse thoroughly in clean water so
no soap remains.
• Once the cleaning process has finished, you must assemble all the elements
in reverse order to their disassembly. Make sure that all the parts have been
correctly assembled and secured.
• Remember that each peel ejector (Fig. 8) only fits on one side and so they are
not interchangeable. When you place them make sure that you insert the peel
ejector paddle right down to the end of the lower pressing unit.
• In order to avoid the accumulation of wax it is important to clean the fruit
feeder frequently of Zumex Versatile Pro models.
• On models with a base stand clean the hopper and the inside of the stand,
making sure to eliminate any peel or pulp remains.
EN
29