Screen Messages - ZUMEX Versatile Pro Manuel De L'utilisateur

Screen Messages

Display Message Cause
Excess current The maximum electrical
consumption level has been
exceeded for at least one
second.
No oranges The motor remains on for
two minutes detecting any
squeezing.
Memory initiated A memory error has been
detected.
Calibration An incorrect calibration value
has been detected.
Out of service The counter has reached zero.
Eeprom Error detected in EEPROM
memory.
Out of range
The input power voltage is
less than 80V or greater than
260V.
Keyboard error (error 1) No communication with the
keyboard (Internal fault).
Juice tray picture flashing Check the juice tray and front
cover are placed correctly.
*The message: "Keyboard error" may not appear on the display as there is no communication between the
CPU and the keyboard panel
Correction
Turn off at mains and turn
back on again.
Put oranges back in feeder
again without and press ON.
Contact your technical service.
Calibrate.
Modify the discounter value as
indicated in page 21 or move
on to counter function entering
PARTIAL COUNTER and
pressing ON.
Contact your technical service.
Contact your technical service.
Contact your technical service.
Place the tray and cover in its
correct position as Fig. 4. If the
picture does not disappear,
contact your technical service.
zumex.com
EN
37