ZUMEX Speed Manuel De L'utilisateur page 25

the frame in a horizontal position and press down until it clips into place.
d) Press down lightly on the sides of the Side Cover (42.5+) and fit it into the holes on
the left hand side of the Frame (Fig. 20.1+). Ensure that the pivots have been inserted
completely, and that the cover can rotate freely. Leave it in the vertical position.
e) Fit the PulpOut System (42+) into the machine (Fig. 20.2+). To do this, fit the left roller
onto the drive shaft on the left side of the machine. Make sure that the assembly rests
and is inserted into the pivots of the container.
f) Turn the Anti-Splash Cap (42.6+) is in a vertical position. It is possible to remove the
PulpOut System without removing the cover.
Note: This item must be in the horizontal position to mount or remove the cover.
For disassembly, follow the steps in reverse. See the Cleaning section for the correct
maintenance of the Automatic PulpOut System.
See how it is fitted in various models:
Speed S +plus (Fig. 3+).
Speed S +plus All-in-One (Fig. 4+).
Speed S +plus Tank All-in-One (Fig. 5+).
Self Service Tap Up (44U), Self Service Tap S
To mount the Self Service tap in the container, line up the rear lug and screw the floating nut
on the rear of the tap (Fig. 3U or 3+).
Note: Remember to thread the floating nut until you can not see the thread any more. If it is
not positioned correctly, the tap sensor will not be activated.
Tap operation
You can make the tap work normally by pressing and releasing it to extract the juice
(Fig. 13 and 14+ (1)). For the SS Tap Up (44U) the button is on the inside on the SS Tap
S+plus (44+) the button is on the outside.
(44+)
+plus
You can anchor the button in "free spout" position. To this end, turn the ring with the
dotted/solid lines until the solid line coincides with the glass symbol. Release the button.
This will secure it (Fig. 13 and 14+ (2)).
To release it, just press the button again (Fig. 13 and 14+ (3)).
For daily cleaning, you can remove the upper part of the tap and the inlet spout (Fig. 13
and 14+ (4)).
The Speed S +plus Self Service Podium has a bottle support (Fig. 14+ (5)) which can be
removed by removing the two rear screws if necessary.
Detector tube gasket (46)
If required, this gasket can be removed for cleaning (Fig. 3U or 4).
Machine supplement (47)
Use this supplement to raise the machine (Fig. 3U or 3+).
Important! Never place the machine onto the supplement alone, it should always be done by
!
at least two people.
Tank Juice Container (50)
Line up the two side lugs at the ends of the container and press. Pressing the side buttons may
help mount it (Fig. 15).
To remove the container, just press the side buttons and pull out towards you.
Tank Sub-filter (51)
Place on the inside of the juice extraction container (Fig. 5+).
EN
47