ZUMEX HORECA & FOOD Minex Manuel De L'utilisateur page 15

MANUAL USUARIO MINEX 11/9/06 17:27 P gina 15
6. DETECTING FAULTS AND SECURITY ADVICES
FAULT POSSIBLE CAUSE
Machine is not on
No voltage
Switch is in OFF position
Cover is not placed correctly
Juice tray is not placed correctly
The machine is not operating
Peel bucket is not placed correctly
Obstructed security detectors
Burned out fused
Detectors damaged
Press button damaged
Faulty circuit
The machine often blocks
Not enough voltage (ALARM 01)
when squeezing
Faulty circuit
The pressing units are not
Internal damage
synchronized
The peel ejector is broken The peel ejector is incorrectly placed
Motor is running but pressing
Internal damage
units are not running
Incorrectly placed
The twirler-blade does
not overturn Oranges blockage (ALARM 03)
Internal damage
The faucet is obstructed The juice has too much pulp or seeds.
Orange is blocked (ALARM 04)
The feeder does not work
Internal damage
IMPORTANT SECURITY ADVICES
The machine must be disconnected before trying to unblock it.
To avoid accidents do not manipulate the machine in order to make it work without the security devices, essentially
the front cover.
Three elements put in action the security detectors: the front cover, the juice tray and the peel bucket. The correct
functioning of the security detector has to be checked periodically. Follow these steps, with the machine on, take apart
one of the three elements and prove that the machine stops. Place it again and repeat the same test with each of the
other two elements. If in some of the three tests the machine does not stop, contact the Technical support service.
If the connection cable is damaged, it has to be substituted with the same cable or special ensemble supplied by the
manufacturer or official distributor.
28
SOLUTION
Connect it
Check the socket
Turn ON the switch
Ensure it is placed correctly. Check the
information on the display. SEG 00100
Ensure it is placed correctly. Check the
information on the display. SEG 00010
Ensure it is placed correctly. Check the
information on the display. SEG 00001
Clean the keyboard cover (Fig.12)
Replace the fuse that is on rear of
the machine (Fig.2).
Contact the Technical support service.
Contact the Technical support service.
Contact the Technical support service.
Check voltage and see if it is within the
permitted limits as indicated in the manual.
Contact the Technical support service.
Contact the Technical support service.
See manual for correct placement
instructions (Fig. 9)
Contact the Technical support service.
Ensure to place the twirler blade +
support set correctly
Remove the blockage.
Contact the Technical support service.
Disassemble and clean the faucet.
See manual for cleaning instructions.
Remove the blockage. Use correct
fruit diameter.
Contact the Technical support service.
ZUMEX, MÁQUINAS Y ELEMENTOS S.A.
Pgno. Inds Moncada II · c/ La Closa, 16
46113 Moncada, Valencia, España
Tel: +34 961 301 251 · Fax: +34 961 301 255
www.zumex.com · zumex@zumex.com
EN
29