Gima ECG90A Manuel D'utilisation page 72

Electromagnetic immunity
Guidance and manufacture's declaration-electromagnetic immunity
The device is intended for use in the environment specified below. Buyer or operator should
assure that it is used in such environment.
Immunity test
Electrostatic
discharge (ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short
interruptions and
voltage vatiations
on power supply
input lines
IEC 61000-4-11
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
NOTE: UT is the a.c. mains voltage prior to application of the test level.
IEC60601 test
level
±6kV contact
±8kV air
±2kV for power
supply lines
± 1 kV for
input/output line
±1 kV lines to
lines
±2 kV lines to
earth
<5%UT(>95%dip
in UT) for 0.5
cycle
40% UT(60%dip
in UT) for 5 cycle
70%UT(30%dip in
UT) for 25 cycle
<5%UT(>95%dip
in UT) for 5 sec
3A/m
Compliance Electromagnetic
level environment-guidance
±6kV contact Floors should be wood,
±8kV air concrete or ceramic tile. If
floor
synthetic
relative humidity should be
at least 30%.
±2kV for power
Mains power quality should
supply lines
be
± 1 kV for
commercial
input/output
environment.
line
±1 kV lines to Mains power quality should
lines be
±2 kV lines to commercial
earth environment.
<5%UT(>95%d
Mains power quality should
ip in UT) for
be
0.5 cycle
commercial
40%
environment. If the user
UT(60%dip in
requires
UT) for 5 cycle
operation
70%UT(30%dip
mains interruptions, it is
in UT) for 25
recommended
cycle
device be powered from an
<5%UT(>95%d
uninterruptible
ip in UT) for 5
supply or a battery.
sec
3A/m Power frequency magnetic
fields should be at levels
characteristic of a typical
location
commercial
environment.
66
is covered with
material, the
that of a typical
or hospital
that of a typical
or hospital
that of a typical
or hospital
continued
during power
that the
power
in a typical
or hospital