Gima ECG90A Manuel D'utilisation page 21

6.1 Installation of recording paper
6.1.1 The device adopts high-speed recording paper, its specification is 50 mm(W)×20 m(L).
6.1.2 The installation method of recording paper is described as below:
1. As shown in Figure 6-1, press the paper compartment cover, it is automatically bounced, take
out the paper axis, insert it into the recording paper as shown in the figure. The paper side with
grids should be faced downwards, and then install it to proper position in the paper compartment,
and press the rubber roller on the recording paper.
2. Pull out the recording paper from the paper exit, and close the cover.
Note
When the paper compartment cover is open, press it again to lock it, no need other

operations.
The recording paper should be aligned with the paper exit. It is recommended to

leave 2cm paper outside.
6.1.3 If the recording paper runs out during recording, the device will stop printing automatically,
and the screen will display a prompt of lack of paper, as shown in Figure 6-2.
Chapter 6 Preparations before Operation
Figure 6-1 Installation of recording paper
Figure 6-2 Lack of paper prompt
15