Publicité
Les langues disponibles
Les langues disponibles
Operation
Convection Steamer Standard Controls
1
3
4
5
BCS-20E Shown
Figure 9
CONTROLS IDENTIFICATION
1. LOW WATER FILL LIGHT --- during the fill
cycle, this light remains on until the water in
the steam generator is at the proper level and
up to temperature. During normal operation the
light should not be on. If the light comes on,
2
check the water level in the steam generator.
NOTE: BCS-20DS, the direct steam unit,
2. POWER ON LIGHT --- when lit indicates pow-
er to the unit is turned on.
3. MODE SELECTOR SWITCH --- turns power
to the steamer on or off.
4. TIMER DIAL --- used to set desired cooking
time.
5. FLUSH/DRAIN SWITCH --- used to flush/
drain the steam generator during decalcifica-
tion.
NOTE: BCS-20DS does not have a flush/drain
OPERATION
NOTE: Before the first use of the appliance, daily
or after the unit has been idle for 5 hours,
preheat with the STEAM function approxi-
mately 1-2 minutes.
1. Turn the SELECTOR SWITCH (3) to STEAM.
2. Set the TIMER (4) for the desired steaming
time or set it to STAY ON. The buzzer will
sound and the unit will shut off when the time
has expired.
3. At the end of the specified time period, the
buzzer sounds and the appliance shuts off au-
tomatically. Move the Timer switch to the STAY
ON position to stop the buzzer and restart the
unit.
4. The Mode Selector Switch is also the main
power switch. In the OFF position the
appliance is not operational.
18
does not have a low water fill light.
switch.
Publicité
