Elcometer NDT PTG6 Mode D'emploi page 19

7 CALIBRATING YOUR GAUGE (continued)
To rename a calibration memory, press Menu/Calibration/Cal
Memory n/Rename Cal Memory n.
To view the calibration memory data, press Menu/Calibration/Cal
Memory n/View Calibration Data.
8 PIN LOCK
The 'PIN Lock' feature prevents the user from accidentally adjusting
the gauge settings.
To set a PIN code:
1 Press Menu/Setup/PIN Lock.
2 Set the four digit PIN code using the
é
softkeys to select 0 to 9 and the
ê
è softkey to move to the next digit .
3 Press 'Ok' to set, 'Escape' to cancel
or 'Adjust' to amend the PIN code.
When enabled, the following features are disabled and can not be
adjusted:
Menu/Limit Memories/Create Limit Memory Menu/Setup/Reading/Measurement Mode
Menu/Limit Memories/Edit Limit Memory
Menu/Calibration/Calibrate
Menu/Calibration/Cal Method
Menu/Calibration/Cal Memory
Menu/Calibration/Factory Calibration
Menu/Reset
To unlock the PIN code:
1 Press Menu/Setup/PIN Lock.
2 Enter the four digit PIN code using the
to 9 and the è softkey to move to the next digit .
3 Press 'Ok' or 'Escape' to cancel.
Note: Should the user forget or lose the PIN code, it can be disabled via
®
ElcoMaster . Using the USB cable supplied, simply connect the gauge to
a PC with ElcoMaster version 2.0.50 or higher installed and select
Edit/Clear PIN.
d
The è softkey will appear when the first 'X' is changed to a number.
www.elcometer.com
All manuals and user guides at all-guides.com
Batch/New Batch/Batch Measurement Mode
Batch/New Batch/Batch Calibration
Batch/New Batch/Batch Limits/Create Limit Memory
Batch/Edit Batch/Delete Batch
Batch/Deleted Reading
®
d
é
softkeys to select 0
ê
d
R
18