Elcometer NDT PTG6 Mode D'emploi page 11

5 SETTING LIMITS - PTG8 (continued)
5.1 CREATING LIMITS FOR INDIVIDUAL READINGS
1 Press Menu/Limit Memories/Create Limit Memory/Set Upper
Limit (or 'Set Lower Limit').
é
2 Use the
ê
3 If required, repeat Step 2 for 'Set Lower Limit' (or 'Set Upper
Limit') and 'Set Nominal'.
4 When all values have been set, use the
highlight 'Save Limit Memory n' and press 'Select' to save.
Limits are specific to the measurement mode in use when created.
4
5.2 CREATING LIMITS FOR A NEW BATCH
1 Press Batch/New Batch/Batch Limits/Create Limit Memory/
Set Upper Limit (or 'Set Lower Limit').
é
2 Use the
ê
3 If required, repeat Step 2 for 'Set Lower Limit' (or 'Set Upper
Limit') and 'Set Nominal'.
4 When all values have been set, use the
highlight 'Save Limit Memory n' and press 'Select' to save.
Limits are specific to the measurement mode in use when created.
4
Batch limits can be viewed at any time via Batch/Review Batch/Batch
4
Information.
5.3 SELECTING SAVED LIMITS
1 Press Menu/Limit Memories/Select Limit Memory or when in
Batching, press Batch/New Batch/Batch Limits/Select Limit
Memory.
é
2 Use the
ê
and press 'Select'.
Only the limits specific to the measurement mode in use are available for
4
selection.
Batch limits can be viewed at any time via Batch/Review Batch/Batch
4
Information.
When a limit memory is in use,
measurement screen, where n = the limit index number.
www.elcometer.com
All manuals and user guides at all-guides.com
softkeys to set the required value and press 'Set'.
softkeys to set the required value and press 'Set'.
softkeys to highlight the limit memory required
é
softkeys to
ê
é
softkeys to
ê
is displayed to the right of the
R
10