Elcometer NDT PTG6 Mode D'emploi page 7

4 GETTING STARTED (continued)
To setup the display:
1 Press Display/Setup Display/Top Display
(or Bottom Display as required).
é ê
2 Use the
required option and press 'Select'.
If 'None' is selected for one half and 'Readings',
'Run Chart' or 'B-Scan' for the other half, the
readings, run chart or B-Scan will fill the whole
screen. If any other combination of options is
selected; the data will be shown in the top or
bottom display as specified.
None; No information is displayed.
Ÿ
Readings; The reading value is
Ÿ
displayed.
Selected Statistics; Up to 8 statistical
Ÿ
values can be displayed as defined by
the user via Display/Statistics/Select
Statistics. Select from:
Number of Readings, Mean, Lowest
Reading, Highest Reading, Standard
Deviation, Low Limit Value, Number
Below Low Limit, High Limit Value,
Number Above High Limit, Range,
Nominal Value.
Run Chart; A line trend graph of the last
Ÿ
20 measurements which is updated
automatically after each reading.
Bar Graph; An analogue representation
Ÿ
of the current measurement value
together with the highest (Hi),
and average (X) reading. The graph is
updated automatically when each
reading is taken.
Readings & Differential ; The last
Ÿ
reading is displayed together with the
variation from the nominal value set via
Menu/Limit Memories/Create Limit
Memory/Set Nominal.
a
Not available in 'Scan Mode' - see Section 9.3 'Taking a Reading in Scan Mode' on page 20.
www.elcometer.com
All manuals and user guides at all-guides.com
softkeys to highlight the
a
lowest (Lo)
Readings & Differential
R
Readings
Selected Statistics
Run Chart
Bar Graph
6