Elcometer NDT PTG6 Mode D'emploi page 12

R
5 SETTING LIMITS - PTG8 (continued)
If a measurement is taken which falls
outside set limits, the appropriate limit
icon, the reading value and the reading
differential (if enabled) turn red, the red
LED flashes and the alarm beeps.
5.4 RENAMING LIMITS
1 Press Menu/Limit Memories/Edit Limit Memory/Rename Limit
Memory.
é
2 Use the
ê
renamed and press 'Select'.
Use the çè softkeys to rename the limit memory.
3
4 Select 'Ok' to save the changes or 'Escape' to exit and
disregard any amendments made.
5.5 AMENDING LIMITS
1 Press Menu/Limit Memories/Edit Limit Memory/Amend Limit
Memory.
é
2 Use the
ê
amended and press 'Select'.
é
3 Use the
ê
Lower Limit') and press 'Select'.
é
4 Use the
ê
5 If required, repeat Steps 3-4 for 'Set Lower Limit' (or 'Set Upper
Limit') and 'Set Nominal'.
6 When all values have been amended as required, use the
softkeys to highlight 'Save Limit Memory n' and press 'Select'
to save the changes.
11
All manuals and user guides at all-guides.com
softkeys to highlight the limit memory to be
softkeys to highlight the limit memory to be
softkeys to highlight 'Set Upper Limit' (or 'Set
softkeys to set the required value and press 'Set'.
é
www.elcometer.com
ê