Elcometer NDT PTG6 Mode D'emploi page 25

11 REVIEWING BATCH DATA - PTG8 (continued)
11.2 BATCH READINGS (Batch/Review Batch/Readings)
Displays the reading value together
with date and time stamp for each
individual reading in the batch and the
cell reference (A1, B3, etc) where the
measurement was taken (for grid type
batches).
é ê
Press the softkeys to scroll
through the readings and è to move to
the next information screen.
Readings outside any enabled limits for
the batch are displayed in red with the
appropriate limit icon to the left of the
reading, ( ) if the reading is below the
low limit and (
11.3 BATCH GRAPH (Batch/Review Batch/Batch Graph)
Allows the users to view the readings within
the batch as a column bar graph. Up to five
horizontal axes as displayed representing
different values / statistics as follows:
Highest reading in the batch (Hi:)
Ÿ
Lowest reading in the batch (Lo:)
Ÿ
Average reading for the batch (
Ÿ
Low Limit (
Ÿ
High Limit (
Ÿ
If limits were not set and enabled, the readings are displayed as
white vertical bars. If limits were set and enabled, readings are
displayed as white bars if within set limits or red; if outside set limits.
If there are more readings in the batch than can be displayed on a
single screen, multiple readings will be combined into one bar.
Should a single reading within the 'combined bar' be outside set
limits, the whole bar will be red.
e
For batches of more than one reading.
www.elcometer.com
All manuals and user guides at all-guides.com
) if above the high limit.
);
when set and enabled
);
when set and enabled
e
e
e
:)
X
R
24