Elcometer NDT PTG6 Mode D'emploi page 31

16 SPARES & ACCESSORIES (continued)
16.3 CALIBRATION STANDARDS
Available as a set or individually, allowing
users to select the most appropriate
thicknesses for their application,
Elcometer calibration standards are
manufactured from 4340 steel to a
tolerance of ±0.1% of the nominal
thickness.
Calibration standard sets and individual
standards are supplied complete with
calibration certificate.
Description
Calibration Standard Set;
Nominal Thickness: 2 - 30mm (0.08 - 1.18")
Comprising of nominal thicknesses; 2, 5, 10, 15, 20, 25 & 30mm
(0.08, 0.20, 0.39, 0.59, 0.79, 0.98 & 1.18") , complete with holder
and calibration certificate.
Calibration Standard Holder
for thicknesses up to 100mm (3.94")
Note: Elcometer recommends that Calibration Standards are wrapped in anti-
corrosion film when not in use.
INDIVIDUAL CALIBRATION STANDARDS
Part Number
T920CALSTD-2
T920CALSTD-5
T920CALSTD-10
f
Calibration standards manufactured in other materials are available on request. Contact Elcometer for
further information.
g
Imperial values for information purposes only. Calibration standards are manufactured and measured in
millimetres.
www.elcometer.com
All manuals and user guides at all-guides.com
f
g
g
Nominal
Thickness
Part Number
g
mm inch
2 0.08 T920CALSTD-15
5 0.20 T920CALSTD-20
10 0.39 T920CALSTD-25
Sales Part Number
T920CALSTD-SET1
g
T920CALSTD-HLD
Nominal
Thickness
mm
15
20
25
R
g
inch
0.59
0.79
0.98
30