Mounting The Bicycle Rack - EUFAB BIKE FOUR Manuel De L'opérateur

Personal injury or property damages caused by increase wind loads.
The bicycle rack and trailer tow bar may be damaged by too high a wind load.
• Remove all bags from the bicycle before starting your journey.
• Do not use protective covers for the bicycle during the journey.
The general operating permit must be carried in the vehicle when the rack is mounted.
Do not travel with the bicycle rack empty. Store it in the boot of your vehicle. This prevents increased fuel consumption and
protects the rack.
The driver is always responsible for ensuring that the load and the load securing meet the regulations.
5. OPERATING INSTRUCTIONS

Mounting the bicycle rack

The bicycle rack must first be assembled. Take all of the components out of the packaging and set them out clearly. Check the scope of delivery. Every stage is
described and clearly shows which components are required for the assembly of the rack.
5.1 MOUNTING THE RACK TABLE
Rack table half, left
Place the left and right halves of the rack table on an even surface with the wheel rail openings facing upwards. Secure the rack traverse to the rack table by
feeding the lock screws from the top through the table and traverse and screwing into from below with washers and nuts. At this point, do not yet tighten the
nuts. Pay attention to ensure that the screws for the license holder are on the outside of the rack travers.
Base
A
Headless hexagonal screws M8 x 55
Washers 15.8 x 8.5 x 1.1
Spring washers
Nut M8
Connect both rack halves with the connection plates and the base. Make sure that the large, central drilled hole of the connection plate lines up with the hole of
the rack table. Push the four headless hexagonal screws from the inside through the connection plate and the square tube (Position A on the diagram). From the
outside, place the base on the ends of the screws. In doing so, the opening for the tow bar must be at the bottom. Secure the base using spring washers and nuts.
Insert the hexagonal screws with washers, from the inside through the outer drilled holes of the connection plate (Position B on the diagram), put the washers
and nuts on the ends of the screws. Now screw the M16 x 1.5 x 90 hexagonal screw approximately one centimetre into the rack base.
Align all of the mounted parts and tighten all screw connections evenly and firmly.
10
Rack table traverse
Lock screw M6 x 70, Washer 17.9 x 6.5 x 1.2, Nut M6
B
Connection plates
Rack table half, right
B
A
Hexagonal screw
M16 x 1.6 x 90
B
Hexagonal screws M8 x 50
Washers 15.8 x 8.5 x 1.1
Nut M8