Installation Of The Rear Lights; Laying Electrical Cables; Mounting The License Plate Holder - EUFAB BIKE FOUR Manuel De L'opérateur

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
Inserting the plugs
Seal the ends of the tubes of the rack table using the rectangular plugs 80 x 30 [mm].
5.2 MOUNTING THE U-SHAPED BAR
Protective rubber
Knob nut M6
Washer 17.9 x 6.5 x 1.2
Push the protective rubber sleeves onto the U-shaped bar. Now mount the U-shaped bar, see pictures 1 and 2.
M6 x 45
M6 x 60
M6 x 30
Figure 1

5.3 INSTALLATION OF THE REAR LIGHTS

Protective mould left
Washer 5 mm
Rear light, left
To mount the rear lights, first place these in the protective moulds. Make sure that the cable is fitted cleanly into the duct and is not crushed. The rear lights
with the reverse light is mounted on the right (in the direction of travel) and the fog light is mounted on the left, in doing so, the openings for license plate
illumination for both lights must be on the inside. Now insert the threaded bolts of the rear lights through the drilled holes in the rack table and screw into place
using washers and nuts.

5.4 LAYING ELECTRICAL CABLES

Lay the cables along the tube of the rack plate. The cables may not be kinked, stretched nor squashed. Secure the cables with the supplied cable ties. When you
are finished, trim any excess material from the cable ties using cutting pliers.

5.5 MOUNTING THE LICENSE PLATE HOLDER

Clips
Mount the license plate holder using the already mounted screws and washers to the rack traverse in such a way that the lamps and the license plate holder are level.
The mounting clips for securing the license plate are push-out parts in the holder. Break out two of the clips. Slide the license plate into the holder, then push
the clips into the cut-outs to secure the license plate.
Lock screw M6 x 60
Nut M6
Figure 2
Cut-out for installation clips
Lock screw M6 x 46
Lock screw M6 x 30
M6 x 45 with washer 17.9 x 6.5 x 1.2 and knob nut M6
M6 x 60 with washer 17.9 x 6.5 x 1.2 and knob nut M6
M6 x 30 with washer 17.9 x 6.5 x 1.2 and nut M6
Nut M5
Rear driving light
U-shaped bar
Stabilisation plate
Protective mould right
Rear light, right
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

11437

Table des Matières