Dismantling The Bicycle Rack; Mounting The Short Tensioning Straps; Mounting The Bicycles To The Rear Rack - EUFAB CROW PLUS Manuel De L'opérateur

from the lock. Store the key carefully and in a safe place. The bicycle rack is
now secured to prevent theft.
Regularly check the rm seating of the rack on the trailer tow bar as well
as the attachment of the bicycles to the rack. Also regularly check the
functions of the lighting system of your bicycle rack.

5.3 DISMANTLING THE BICYCLE RACK

In order to unfold the bicycle rack, start by swivelling the rear lights
outwards. The light mounts are clipped onto the rack table. Pull the
light mounts out of the clips. Pull the locking mechanism back (Position
1 in Figure 12). Hold the locking mechanism in this position. Swivel the
light mount out fully (Position 2 in Figure 12). Now release the locking
mechanism (Position 3 in Figure 12), the light mount is now secured to
prevent it from folding back in.
Figure 12: Locking the light mounts
Fold open the bicycle rack as shown in the following Figures.
1. Fold out the right rear light 1. Fold out the right rear light
2. Fold out the left rear light 2. Fold out the left rear light
3. Fold out the right wheel rail 3. Fold out the right wheel rail
4. Fold out the left wheel rail 4. Fold out the left wheel rail

5.4 MOUNTING THE SHORT TENSIONING STRAPS

Figure 13: 6 x short tensioning strap
Bild 14: Montage Spanngurte
Insert the short tensioning strap from the inside to the outside below the
bike holder and then from the outside to the inside through the slots of the
bike holder (Figure 14). For the rear wheel of the bicycle, use the centre
slot of the wheel holder, for the front wheel, use the two outer slots (two
tensioning straps to prevent the front wheel from turning).

5.5 MOUNTING THE BICYCLES TO THE REAR RACK

The rst bicycle is placed in the rst bicycle rail (closest to the vehicle) and
secured to the U-shaped bracket with the short frame holder. To do this, use
the side of the frame holder with the tensioning strap to secure to the bicy-
cle frame. The wheels are secured by placing the tensioning straps around
the wheel rim of your bicycle and tightening the straps. Caution: The front
wheel must be secured with two small tensioning straps to prevent it from
turning (Figure 15). The second bicycle is used placed in the second rail,
facing the opposite direction and secured to the U-shaped bracket with the
long frame holder. The wheels are secured in the same way as for the rst
bicycle. It may be necessary to o set the individual bicycles di erently on
the rack to ensure that the frame holders may be correctly secured. Now
secure the bicycles with the long safety strap. Wrap the safety strap through
the bicycle frames and the U-shaped bracket and tighten. (See Figure 16)
Without this safety strap, the bicycle rack may not be
used.
Figure 15: Tensioning straps for front wheel
Safety strap
Figure 16: Safety strap
11