Laying The Electrical Cables; Mounting The Short Tensioning Strap; Mounting The Plastic Cover; Mounting The Bicycle Rack On The Trailer Tow Bar - EUFAB 11559 Mode D'emploi

Inserting the license plate
The mounting clips for securing the license plate are push-out parts in
the holder. Break out two of the clips. Slide the license plate into the
holder, then push the clips into the cut-outs to secure the license plate.
6.1.6

Laying the electrical cables

Secure the cables of the lights to the underside of the rack using the supplied cable ties. Make sure that the cables cannot be damaged during
travel.
6.1.7

Mounting the short tensioning strap

Insert the short tensioning strap from the inside to the outside below the bike holder and then from the outside
to the inside through the slots of the bike holder (see photo) (see also section 6.3).
6.1.8

Mounting the plastic cover

Fit the plastic covers onto the middle of the wheel rail.
Result of Step 3
6.2

Mounting the bicycle rack on the trailer tow bar

Before you put the bicycle rack on the trailer tow bar, familiarise yourself with the quick locking system.
12
Fastening bolt
Lock nut
Adjusting screw for quick locking
system
Clips
Cut-outs
Lever
Lock