Operating Instructions; Mounting The Bicycle Rack; Mounting The Wheel Rails; Mounting The Lamp Mount - EUFAB 11559 Mode D'emploi

Property damage due to opening tailgate.
• The tailgate could hit the bicycle rack and be damaged.
• Switch o the electric tailgate and operate it manually.
• Remove the bicycle rack before opening the tailgate.
Property damage caused by hot exhaust gases.
Damages may be caused to the rack or bicycle if the exhaust outlet is close by.
• Use an exhaust de ector if necessary.
Personal injury or property damage possible due to a damaged bicycle rack.
Damage to the rack, e.g. bent parts, cracks or scratches, prevents the safe operation of the rack.
• Do not mount the bicycle rack if it is damaged in any way.
• Proceed as described in the chapter on Maintenance.
Personal injury or property damage due to loss of the bicycle rack while driving.
A loose or faulty connection between the bicycle rack and trailer tow bar can lead to the detachment of the bicycle rack.
• Replace a defective trailer tow bar.
• Clean the trailer tow bar of dirt, dust and grease.
The general operating permit must be carried in the vehicle when the rack is mounted.
6.

Operating instructions

The bicycle rack must rst be assembled. Take all of the components out of the packaging and set them out clearly. Every stage is described and
clearly shows which components are required for the assembly of the rack.
6.1

Mounting the bicycle rack

Step 1
Components:
Cross-headed
screw
M5 x 35
6.1.1

Mounting the wheel rails

Place the wheel rail halves, with the plastic shells on the outside, parallel on the base frame so that the drilled holes in the rail match the holes
in the base frame. Secure each wheel rail to the base frame with the two lock screws M6 x 50, washers and self-tapping nuts M6.
6.1.2

Mounting the lamp mount

Join the two halves of the lamp mount together. This is made easier by the small guide element
which is already mounted on one side. Push the rails together and secure the connection with the
cross-headed screw (M5x12) and washer.
Insert the cross-headed screws M5 x 35 with spring washers and washers, from below, th-
rough the vertical drilled holes of the lamp mount. Insert the screws through the threaded
holes on the underside at the end of the lamp mount. Tighten the screws.
Make sure that the fog light is installed on the left side of the mount!
10
Base frame
Cross-headed
screw
M5 x 12
Wheel rail halves
Lamp mount set
Lock screw
M6 x 50